Research on the possibilities of using support ropes in belts for the transmission of energy and electrical signals

  • Grzegorz Śmigielski Kazimierz Wielki University, Faculty of Mechatronics
  • Grzegorz Domek Wilhelm Herm. Müller Polska
  • Mateusz Domeracki Kazimierz Wielki University, Faculty of Mechatronics
  • Piotr Krawiec Poznań Technical University, Faculty of Mechanical Engineering
  • Elżbieta Gawrońska Częstochowa Technical University, Faculty of Informatics and Artificial Inteligence
Keywords: drive belts, suspension cables, mechatronic belts, belt sensors

Abstract

Flat and toothed belts, whose supporting layer is made of a series of steel cords, can be used to transmit very high torques and large forces. For several years, attention has been paid to the possibility of using these cords to transmit electrical energy, and recently, attempts have been made to transmit electrical signals as well. In earlier elevator solutions from companies like OTIS, sending electric signal through steel cables allows for monitoring their technical condition. The authors attempted to measure the resistance in the diagonal strip, of resistance, of individual lines and the resistance between lines in order to determine the possibility of using them to transmit electricity.
Of course, another problem, besides safety, is the possibility of overheating, which can lead to belt deformation. Current leakage between adjacent cables can also occur, so this problem should be identified for different types of suspension cables and different types of belts. Modern belts are equipped with various types of sensors that can be connected to the suspension cables. Very often, when open belts are used in robots and manipulators, a signal is transmitted via the supporting cables to the actuator located at the end of the robot arm.

Published
2026-05-29
Section
Transport & Logistics